Guy wire preform color code registration#

The dynamometer and come-along are then removed, and the turnbuckle is adjusted to maintain the registration points measured.China Preformed suspension,ADSS suspension,Suspension grip Manufacturers and Suppliers.Our company has good design, professional team, and the competitive price.We look forward to establishing a long-term relationship with you. Two registration points are then marked, one above the clamping point on the guy wire and one on the anchor shaft, and the control length is measured. The guy tension is then read off the dynometer dial.īy adjusting the come-along the proper installation tension will be attained when registered on the dynamometer.

The come-along is then tightened until the original turnbuckle begins to slacken, allowing the dynometer to carry the guy load to the anchor. Check construction drawings for site-specific initial tension requirements.Ī dynomometer with a length adjustment device, such as a come-along, is attached to the guy system by clamping onto the guy just above the turnbuckle and onto the anchor shaft below the turnbuckle. There should be relatively little wind when taking the measurements.

The below chart will indicate how many cycles per minute there should be for the accompanying guy wire length of all sizes.Īmbient temperature affects tower guy tensions and must be considered when adjustments are made. Push lightly on the guy to maintain the motion while counting. When the guy is swinging slightly and easily in a side-to-side single arc, begin to count as it hits your raised index finger. Grasp the guy wire in front of the anchor and start a horizontal pendulum-like motion by pushing from side to side. The most common application of this method is the Sag Intercept method. Another tool measures the harmonic frequency of the guy wires and runs $2,900.00 list for measuring the tension of wires up to 3/4”.Īlthough not as reliable as other methods, an oscillation technique can be used to identify the approximate tension when all of your testing equipment is on another job site. The indirect method uses assumptions and calculations to predict the tension. A mechanical dynamometer capable of measuring up to 20,000 lbs. The direct method uses mechanical or hydraulic equipment to pull the guy wire to measure the tension with a calibrated gauge. Direct and indirect are the two common methods of measuring guy tension on towers. Initial tension may be mesured by vibration frequency, mechanical tensionmeters, measurement of guy sag, or by other suitable methods.

The installed tension for guy wire is typically 10% of the wire’s breaking strength. Preform Grips - Cable Clamps - Thimbles - Dead End SleevesĪligning yourself with the right tensioning tools Additional information can be found in EIA/TIA 222F. Check construction drawings for site specific initial tension requirements. *Typical pretensioning is 10% of the breaking strength. We recommend that you contact our valued distributors for your site-specific guy wire and attachment hardware requirements. Use the guy wire calculation program to quickly identify the total length of guy wire that the project will require. To allow for sag and tensioning, 5 to 10% should be added to your guy wire lengths. The following average distributor pricing for EHS galvanized steel guy wire, preformed grips, cable clamps, thimbles, dead end sleeves and turnbuckles does not include taxes or freight.

Guy wire preform color code